Spear Exim Private Limited

As per ASTM D4217 , DIN 55990- P8

Gel Time Apparatus is used for determination gel time of powder coating or sample at which time it turns into gel on a polished metal surface at specific temperature. Gel time is the time at which the sample turns into gel from solid and it is not able to be used further. Gel time apparatus is made from non corrosive material. The top plate is made up of aluminium and it is provided with a sensor. It has a long lasting heating coil, temperature controller and digital timer display. It is widely used in plastic industries, powder coating.

Cleveland Open Cup Flash Point Tester

ASTM D-92, IP 36

This test method describes the determination of the flash point of petroleum products by Cleveland open cup apparatus.

Construction – Made in stainless steel 304.Heater - 4 inch diameter caster iron hot plate.

Temperature controller – energy regulator temperature controller.

 

Features

• The equipment consists of open cup.
• Heating air bath with energy regulator temperature controller.
• Gas regulator
• Test assembly with oil cup, gas ignition device & lifting handle for oil cup.
• Power supply : 230 volt AC. 1 phase, 50Hz.
• Temperature :  Up to 350°C

The Digital Bulk Density Apparatus is a microprocessor based instrument designed to study the packing down of powder beds of different pharmaceutical & chemical powders and gives accurate & repeatability of the result.

Bulk Density is an essential test required in the process of Tablet manufacturing, capsules filling and cosmetics manufacturing as important part of quality control program. 4 digit microprocessor based Pre-set counter provided to set exact no of strokes. This feature eliminates the tedious calculation of Timer Mode. A common holder for both the cylinder drops down smoothly from the specified height. Easy to lock cushioned holders are provided to hold the cylinder. In power failure, the non-volatile memory of the microprocessor remember the last mode of operation, and complete the test after the power supply is resumed. It has the following features:

Specifications :

» Display: Digital 12 mm Red LED
» Speed range - 30 RPM

Mechanical Timer/Digital counter as per customer requirement